Description
Swimo IV is closer to the electrical box with screen and integrated automatic processing than the Swimo III controller
We find the controller in DIN Module form and these few differences
Different functions Swimo III Swimo IV
On-board control relay 0 9 x 5A
Relay control signals (12V coil) 15 6 (tablecloth)
Box of 8 relays of 8A NC + 8A NO Yes No
Analog Analysis No Yes (Solista)
Input for NTC temperature sensor No Yes
Input for industrial sensor 4-20mA(12V) No Yes (2)
4.3' color screen on the front No No
Integrated automatic treatment CL/PH (or other) No Yes
End of can sensors and injection accessories No Yes
Built-in 10 and 20 A power contactors No Yes
12V power supply with galvanic protection No Yes
Relay tripping protection at boot No Yes
Note that even if the controller failure is very rare (short circuit), On Swimo III the relays are on by default (relay test) while on Swimo IV, the controller must have finished its boot to authorize the ignition of the relays.
SOLO Modbus analysis chamber (temperature, PH, Redox, Conductivity) and its 3 meter cable
Solo Modbus Lite
Maestro user guide
In terms of control, the controller sends a web interface on the ip 192.168.240.1 on its own WIFI network (swimo-xxxxx) if it is not connected to the internet.
the admin page 192.168.240.1/admin.hml, allows you to define the equipment present as the front screen, very practical for limiting its use.
It can also be controlled and configured with the SWIMO and SWM-smart water management (latest generation) applications.
Delivered with all the injection accessories and its mounted injection block
Seko injection block
Delivered with its pre-filter to protect the probe assembly
Pre filter with support
Technical Data
Format | |
---|---|
Box | 250 x 350 x 130 mm |
Entrances | |
Tors | 6 All or nothing inputs |
Temp | NTC temperature signal 10 to 30k |
0-5 | 0-5 volt signal for all types of sensors |
4-20 | 2 inputs 4-20 mA in 12V |
Eth | 100mb/s ethernet port |
Usb | USB A port for android display or 4G dongle |
Modbus | 12V modbus port |
Outputs | |
Signals | 6 external signals possible relay with 12V coil |
Relay | |
Control | 9 built-in 5A NO relays |
Power | 6 power contactors 10 and 20 A |
To analyse | |
Solo Modbus | PH, Temperature, ORP, Conductivity, Flow |
cable | length 3 meters |
Treatment | |
Dosage | 2 integrated dosing pumps for liquid chlorine, active oxygen, ph+, ph- according to customer needs, delivered with all related accessories. |